Programming manual.
CNC 8070
THE SPINDLE. BASIC CONTROL.
7.
Spindle orientation.
·133·
(REF: 1709)
How to know the type of spindle.
The type of spindle may be checked directly in the machine parameter table or using the
following variables.
(V.)SP.SHORTESTWAY.Sn
Variable that can only be read from the PRG and PLC.
This variable indicates whether the spindle Sn orients via the shortest way. This variable
returns a ·1· if so.
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
On power-up, after executing an M02 or M30, and after an emergency or reset, the CNC
cancels the turning direction set by the user.
To Next Page
Loading...
