Programming manual.
CNC 8070
8.
PATH CONTROL.
Circular interpolation (G02/G03).
·146·
(REF: 1709)
Considerations for the feedrate.
• The programmed feedrate "F" stays active until a new value is programmed, thus not
being necessary to program it in every block.
• The programmed feedrate "F" may be varied between 0% and 200% using the selector
switch on the CNC's operator panel or it may be selected by the program or by the PLC.
However, the maximum override is limited by the OEM (parameter MAXOVR).
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
• Functions G02 and G03 may also be programmed as G2 and G3.
• Functions G02 and G03 are modal and incompatible with each other and with G00, G01,
G33 and G63. Function G74 (Home search) also cancels functions G02 and G03.
• On power-up, after an M02 or M30 and after an emergency or a reset, the CNC assumes
function G00 or G01 as set by the OEM (parameter IMOVE). If the CNC assumes the
function G00, and this function is defined as non-modal (parameter G0MODAL), after
programming G1, G2 or G3, the CNC assumes G1 as a modal function.
To Next Page
Loading...
