Programming manual.
CNC 8070
8.
PATH CONTROL.
Arc defined by three points (G09).
·166·
(REF: 1709)
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
• Function G09 may also be programmed as G9.
• Function G09 is not modal, so it should always be programmed if you wish to execute
an arc defined by three points. After executing the function, the CNC restores the G00,
G01, G02 or G03 function that was active before.
Programming example.
To Next Page
Loading...
