Programming manual.
CNC 8070
12.
ADDITIONAL PREPARATORY FUNCTIONS
Dwell (G04 / #TIME).
·226·
(REF: 1709)
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
Function G04 is not modal, therefore, it must be programmed every time a dwell is desired.
Function G04 may also be programmed as G4.
#TIME [5]
#TIME 5
(5 second dwel)
P1=2
#TIME [P1]
#TIME P1
(2 second dwel)
P1=2
#TIME [P1+3]
(5 second dwel)
To Next Page
Loading...
