Programming manual.
CNC 8070
ADDITIONAL PREPARATORY FUNCTIONS
12.
Software limits.
·229·
(REF: 1709)
Axes out of position.
If after setting the new limits, an axis positions beyond them, it will be possible to move that
axis towards the work zone (between those limits).
Programming on a lathe (radius/diameter).
The software limits are always defined in radius, regardless of the setting of parameter
DIAMPROG and the active function G151/G152.
Restore the software limits set in the machine parameters.
The software limits set in the machine parameters may be restored by program using their
variables.
Properties of the function and Influence of the reset, turning the
CNC off and of the M30 function.
On power-up or after validating the axis machine parameters the CNC assumes the software
limits set by the machine parameters. After an M02 or M30 and after an emergency or a reset,
the CNC maintains the software limits set by G198 and G199 or their equivalent variables.
G198 X[V.MPA.NEGLIMIT.X] Y[V.MPA.NEGLIMIT.Y]
G199 X[V.MPA.POSLIMIT.X] Y[V.MPA.POSLIMIT.Y]
(The CNC restores the limits set in the machine parameters)
To Next Page
Loading...
