Programming manual.
CNC 8070
14.
SUBROUTINES.
Assistance for subroutines.
·284·
(REF: 1709)
Where to save the help files.
The machine manufacturer can save the help files in the folders ..\Mtb\Sub\Help and
..\Mtb\Sub\Help\{language}. Since the modifications to the MTB directory in the "User" work
mode disappear when turning the unit off, the user must save his help files in the folder
..\Users\Sub\Help and ..\Users\Sub\Help\{language}.
The CNC looks for the files in the following order and displays the first that it finds, this is
the reason why it is recommended that the user does not define subroutines and/or help files
with the same name as those of the OEM. If there are no help files, the CNC will not show
any help and it will not display an error.
..\Users\Sub\Help\{idioma}
..\Users\Sub\Help
..\Mtb\Sub\Help\{idioma}
..\Mtb\Sub\Help\
For versions V1.60 (8060) y V5.60 (8065), the CNC no longer searches for help files in the following
folders.
..\Users\Session\Help\{idioma}
..\Mtb\Sub\Help\{idioma}.
..\Users\Help\{idioma}.
For versions prior to V1.60 (8060) and V5.60 (8065), the CNC first searched for the help files in the
manufacturer folders and then in the user folders. For these and later versions, it does so in the opposite
order.
To Next Page
