Fagor 8070 BL - Page 364

Programming manual.
CNC 8070
20.
HSC. HIGH SPEED MACHINING.
User subroutines G500-G501 to turn HSC on/off.
·364·
(REF: 1709)
Subroutine G501 supplied by Fagor (may be modified by the user).
; -----------------------------------------
; -----------------------------------------
; HSC ACTIVATION
;
; OPTIONAL PARAMETERS
;
; E - CONTOUR TOLERANCE
; A - % ACCELERATION
; J - % JERK
; M - HSCMODE
; 1 SURFACE
;2 FAST
;3 CONTERROR
;
; -----------------------------------------
; -----------------------------------------
#ESBLK
#HSC OFF
#PATHND ON
; --------------------HSC MODE ------------
$IF V.C.PCALLP_M
$IF [P12 == 1]
#HSC ON [SURFACE]
$ELSEIF [P12 == 2]
#HSC ON [FAST]
$ELSEIF [P12 == 3]
#HSC ON [CONTERROR]
$ENDIF
$ELSE
#HSC ON
$ENDIF
; --------------------CONTOUR TOLERANCE----
$IF V.C.PCALLP_E
#HSC ON [EP4]
$ENDIF
; --------------------ACCELERATION --------
$IF V.C.PCALLP_A
G131 P0
$ELSE
G131 100
$ENDIF
; --------------------JERK-----------------
$IF V.C.PCALLP_J
G133 P9
$ELSE
G133 100
$ENDIF
#RETDSBLK