Fagor 8070 BL - Page 366

Programming manual.
CNC 8070
20.
HSC. HIGH SPEED MACHINING.
User subroutines G500-G501 to turn HSC on/off.
·366·
(REF: 1709)
Example of a G501 subroutine. Turn HSC on in FAST mode.
Example of a G502 subroutine. Turn HSC on in SURFACE mode.
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
; HSC ROUGHING ACTIVATION
; E - Contour Tolerance
; A - % Acceleration
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
#ESBLK
#HSC OFF
#PATHND ON
$IF V.C.PCALLP_A
G131 P0
$ELSE
G131 100
$ENDIF
$IF V.C.PCALLP_E == 0
P4 = 2 * V.MPG.HSCROUND
$ENDIF
#HSC ON [FAST, EP4]
V.G.DYNOVR = 120
#RETDSBLK
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
; HSC FINISHING ACTIVATION
; E - Contour Tolerance
; A - % Acceleration
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
#ESBLK
#HSC OFF
V.G.DYNOVR = 100
#PATHND ON
$IF V.C.PCALLP_E == 0
P4 = V.MPG.HSCROUND
$ENDIF
$IF V.C.PCALLP_A
G131 P0
$ELSE
G131 100
$ENDIF
#HSC ON [SURFACE, EP4]
#RETDSBLK