Programming manual.
CNC 8070
22.
STATEMENTS AND INSTRUCTIONS
Programming statements
·406·
(REF: 1709)
Position synchronization
(V.)[n].A.SYNCPOSW.Xn
Read-only from the PRG, PLC e INT.
When the spindles are synchronized in position, the slave spindle follows the master keeping
the programmed offset (taking the ratio into account). If the value defined in this variable is
exceeded, the SYNCPOSI signal goes low; the movement is not stopped and no error
message is issued.
Its default value is that of machine parameter DSYNCPOSW.
(V.)[n].A.SYNCPOSOFF.Xn
Read-only from the PRG, PLC e INT.
Position offset.
To Next Page
Loading...
