Operating manual
CNC 8070
SETUP ASSISTANCE
20.
(REF: 1505)
·359·
The Bode diagram
Vertical softkey menu.
Depending on which data has the focus, the vertical softkeys show different options.
Zone 1. Focus on a type of graph.
When the focus is on any type graph, the following vertical softkeys will be shown.
Zone 2. Focus on the "ABSCISSA" field
When the focus is on the "ABSCISSA" field, the following softkeys will appear.
Zone 3. Focus on the "WIN", "C1" and "C2" field.
Cursors "C1" and "C2" may be used to analyze each signal of the last data capture. These
two cursors may be used to obtain the position in milliseconds or Hertz of each signal and
the time difference between them """.
When the focus is on one of these fields, the following vertical softkeys will be shown.
The scale of the graphic may be changed with the "scale" softkeys.
The new scale value will appear on the graphic, in the same color
as the type of graph.
The desired graph may be moved up and down using the offset
softkeys.
This softkey may also be used to center the graphics.
When the focus is on any of the variables, any type of graph may be either selected without having
to go to the configuration screen or having to do another capture.
Using the autoscale softkey, the Bode selects the right time scale
frequency scale so the signal appears as large as possible inside
its corresponding graphic area.
It increases or decreases the time scale or frequency scale.
It takes the window to the beginning or to the end.
To Next Page
Loading...
