·360·
Operating manual
CNC 8070
20.
SETUP ASSISTANCE
(REF: 1505)
The Bode diagram
Zone 4. Focus on the "parameter name" field.
Its value may be modified by selecting the various parameters. When pressing [ENTER] after
selecting a parameter, use the [][]
[][] keys to move the focus to the next field to change
the value of that parameter. After changing the parameter value and pressing [ENTER], the
focus does not go on to the next field. Use the arrow keys to go on to the next parameter.
When the focus is on this field, the 4 vertical softkeys will be:
It takes the window to the trigger. If there is no trigger, it will go to
the center of the window.
Moves the window to the left or to the right.
It increases the value of the parameter in the amount indicated on the
configuration screen.
It decreases the value of the parameter in the amount indicated on the
configuration screen.
It resets the parameter to its default value.
It validates the value given to the parameter.
To Next Page
Loading...
