Fagor CNC8 070 - The CNC Must be Restarted too Assume Changes in the HMI Table; The CNC Must be Restarted too Assume Changes in Tool Magazine Table; Maximum Jogging Feedrate Exceeds Maximum Feedrate Set for Axis; Manual Rapid Feedrate Exceeds Maximum Feedrate Set for Axis

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 4 of 128
Errors 0000-0999
0058 'The CNC must be restarted too assume the changes in the HMI table,'
DETECTION Machine parameter validation.
CAUSE The CNC must be restarted in order to assume the changes made to the HMI table.
SOLUTION Restart the CNC.
0059 'The CNC must be restarted too assume the changes in the tool magazine table,'
DETECTION Machine parameter validation.
CAUSE The CNC must be restarted in order to assume the changes made to the tool
magazine table.
SOLUTION Restart the CNC.
0060 'The maximum jogging feedrate exceeds the maximum feedrate set for the axis'
DETECTION Machine parameter validation.
CAUSE Machine parameter MAXMANFEED greater than G00FEED.
SOLUTION Decrease MAXMANFEED.
0061 'The manual rapid feedrate exceeds the maximum feedrate set for the axis'
DETECTION Machine parameter validation.
CAUSE Machine parameter JOGRAPFEED greater than G00FEED.
SOLUTION Decrease JOGRAPFEED.
0062 'The Continuous Jog feedrate exceeds the maximum feedrate set for the axis'
DETECTION Machine parameter validation.
CAUSE Machine parameter JOGFEED greater than G00FEED.
SOLUTION Decrease JOGFEED.
0063 'The Incremental Jog feedrate exceeds the maximum feedrate set for the axis'
DETECTION Machine parameter validation.
CAUSE Machine parameter INCJOGFEED greater than G00FEED.
SOLUTION Decrease INCJOGFEED.
0064 'The master and slave axes must have the same I0TYPE'
DETECTION Machine parameter validation.
CAUSE The Io types of the Gantry axes are not the same.
SOLUTION Change the value of machine parameter I0TYPE.
0065 'A Hirth axis cannot be Gantry"
DETECTION Machine parameter validation.
CAUSE The CNC does not admit pairs of Grantry axes that are Hirth axes.
SOLUTION Remove the Gantry pair or make a Gantry pair with axes that are not Hirth.
0066 'A Gantry axis cannot have REFSHIFT'
DETECTION Machine parameter validation.
CAUSE One of the axes of the Gantry pair has the machine parameter REFSHIFT (offset
referred to the reference point) other than 0 in one of its SETs (parameter sets).
SOLUTION REFSHIFT = 0.
0067 'A Gantry axis cannot be Unidirectional'
DETECTION Machine parameter validation.
CAUSE An axis with a single rotating direction (UNIDIR) cannot be Gantry.
SOLUTION UNIDIR = 0.
0068 'Gantry Axes: the slave cannot go before the master in AXISNAME'
DETECTION Machine parameter validation.
CAUSE The slave axis is above the master axis in the axis name assigning tables
(AXISNAME).
SOLUTION Swap the axis names in AXISNAME or swap the master and the slave axes of the
Gantry pair.