CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 80 of 128
Errors 2000-2999
2007 'While G138 is active, G40 is not allowed after the first compensation block'
DETECTION During execution.
CAUSE Tool radius cancellation (G40) has been programmed while the first compensation
block is being processed in a direct selection (G138).
SOLUTION Using direct compensation selection (G138) requires an additional block of motion
in the plane in order to complete the beginning of the compensation and then be able
to cancel it. Another option is to use the indirect compensation selection (G139) that
does not need an additional block.
2008 'While G138 is active, no G41/G42 change is allowed after the first compensation
block'
DETECTION During execution.
CAUSE While processing the first compensation block of a
direct selection (G138), a change from G41 to G42 or viceversa has been
programmed.
SOLUTION Using direct compensation selection (G138) requires an additional block of motion
in the plane in order to complete the beginning of the compensation. The type of
compensation may be changed after this movement. Another option is to use the
indirect compensation selection (G139) that does not need an additional block.
2010 'Tool radius too large when calculating tool radius compensation between arcs'
DETECTION During execution.
CAUSE The tool radius is too large for the programmed arc.
SOLUTION The possible solutions are:
• Program a smaller tool radius to machine the programmed arc.
• Eliminate the arc from the programmed profile.
• Program a larger arc.
2011 'Compensation movement on circular path (profile damaged)'
DETECTION During execution.
CAUSE The tool radius is too large for the programmed arc.
SOLUTION The possible solutions are:
• Program a smaller tool radius to machine the programmed arc.
• Eliminate the arc from the programmed profile.
• Program a larger arc.
2013 'Different tool radius between previous path and an arc'
DETECTION During execution.
CAUSE The error comes up because when compensating an arc, the tool radius has changed
with respect to the previous block.
SOLUTION Do not change the tool radius when compensating an arc.
2016 'The profile has been changed to avoid a collision'
DETECTION During execution.
CAUSE The process of detecting collisions or steps during tool compensation has detected
a tool movement that could damage the programmed profile and it has eliminated it.
SOLUTION Depending on the collision detected, it may be solved by using a tool of a smaller
radius, programming the profile in a different way or simply accepting the change
proposed by the collision detecting process.
2017 'Programming not allowed while collision detection is active'
DETECTION During execution.
CAUSE While detecting collisions, certain processes like home search, probing, etc. are not
allowed.
SOLUTION Do not activate collision detection if any of these processes has been programmed.
2100 'Positive software limit overrun in G5-G60'
DETECTION During execution.
CAUSE The path generated by the CNC to round the corner is out of the active travel limits.
SOLUTION Program without G50 or G7 rounding .
To Next Page
Loading...
