CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 89 of 128
Errors 3000-3999
3504 'Acceleration changing speed greater than the maximum'
DETECTION During startup or execution.
CAUSE An acceleration changing speed greater than the maximum has been programmed.
SOLUTION Program a smaller value than the maximum for the speed.
3505 'Jerk limit overshoot'
DETECTION During execution.
CAUSE Jerk overshoot on this path.
SOLUTION Contact your Fagor supplier.
3506 'The Jerk limit will be exceeded'
DETECTION During the execution of the command to analyze the frequencies.
CAUSE The frequency is too high for the programmed amplitude.
SOLUTION Decrease the maximum frequency or decrease the amplitude.
3507 'Acceleration limit exceeded'
DETECTION During execution.
CAUSE Too much acceleration on this path.
SOLUTION Contact your Fagor supplier.
3508 'Frequency too high for the programmed speed'
DETECTION During the execution of the command to analyze the frequencies.
CAUSE The additive speed is lower than the one resulting for the maximum frequency.
SOLUTION Decrease the maximum frequency or program a higher additive speed.
3600 'Zero spindle speed'
DETECTION During execution.
CAUSE No spindle positioning speed has been programmed.
SOLUTION Check the programming and make sure that parameters REFFEED2 and G00FEED
of the active spindle gear are not zero.
3601 'Programmed spindle speed greater than the maximum limit'
DETECTION During execution.
CAUSE A spindle speed has been programmed that is greater than the maximum set by
machine parameter for the gear being used.
SOLUTION Check spindle parameter G00FEED.
3602 'The spindle cannot be moved in DRO mode'
DETECTION During execution.
CAUSE Spindle in DRO mode via PLC. DROS = 1 and SERVOSON = 0.
SOLUTION Check spindle marks DRO and SERVO in the PLC program.
3603 'The commanded spindle position exceeds the module range'
DETECTION During execution.
CAUSE An attempt has been made to position the spindle in a coordinate that is out of the
range set by machine parameters MODUPLIM and MODLOWLIM.
SOLUTION Check parameters MODUPLIM and MODLOWLIM
3604 'Spindle positioning direction contrary to the setting of the machine parameter'
DETECTION During execution.
CAUSE A positioning has been programmed that requires a spindle move in the opposite
direction to what has been set by machine parameter UNIDIR.
SOLUTION Check spindle machine parameter UNIDIR.
3605 'Spindle turning direction contrary to the setting of the machine parameter'
DETECTION During execution.
CAUSE A rotation has been programmed that requires a spindle move in the opposite
direction to what has been set by machine parameter UNIDIR.
SOLUTION Check spindle parameter UNIDIR .
To Next Page
Loading...
