CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 69 of 128
Errors 1000-1999
1788 'CIRCULAR POCKET: S = 0'
DETECTION Executing circular pocket cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1789 'CIRCULAR POCKET: T = 0'
DETECTION Executing circular pocket cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1790 'CIRCULAR POCKET: P = 0'
DETECTION Executing circular pocket cycle.
CAUSE P (pocket depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1791 'CIRCULAR POCKET: tool diameter smaller than DELTA'
DETECTION Executing circular pocket cycle.
CAUSE The diameter of the roughing or finishing tool is smaller than the roughing or finishing
pass in the XY plane.
SOLUTION Decrease the size of the milling pass in XY (DELTA) or machine with a tool that has
a larger diameter.
1792 'CIRCULAR POCKET: tool diameter greater than the pocket'
DETECTION Executing circular pocket cycle.
CAUSE The diameter of the roughing or finishing tool is greater than the R radius of the pocket.
SOLUTION Choose a tool of a smaller diameter to make the pocket.
1793 'CIRCULAR POCKET: Finishing tool diameter smaller than delta'
DETECTION Executing circular pocket cycle.
CAUSE The diameter of the finishing tool is smaller than the finishing stock in the XY plane
(delta).
SOLUTION Choose a tool of a larger diameter to make the pocket.
1794-1800'Tool diameter = 0'
DETECTION Executing a canned cycle.
CAUSE The radius of the roughing or finishing tool is 0.
SOLUTION Correct the value of the tool radius in the tool table.
1801-1803'Beta or theta < 0 or Beta or theta > 90'
DETECTION Executing a pocket.
CAUSE In a pocket, a lateral penetration angle has programmed for roughing (beta) or for
finishing (theta) that is not between 0º and 90º.
SOLUTION Correct the values of beta or theta.
1804 'G87: Depth = 0'
DETECTION Executing a G87 pocket.
CAUSE The programmed I coordinate is the same as the Z coordinate plus the D distance.
If Z has not been programmed, the I coordinate is the same as the current position
plus the D distance. This means that the pocket has no depth.
SOLUTION Modify the parameters involved I, Z and/or D.
1805 'G87: tool diameter greater than the pocket'
DETECTION Executing a G87 pocket.
CAUSE The tool radius is greater than the J and/or K dimensions of the pocket.
SOLUTION Select a tool with a smaller radius.
1806 'G87: tool diameter smaller than L'
DETECTION Executing a G87 pocket.
CAUSE The tool diameter is smaller than the finishing stock L.
SOLUTION Select a tool with a larger radius.
To Next Page
Loading...
