CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 36 of 128
Errors 1000-1999
1305 'Programming not allowed while #MCS is active'
DETECTION During execution.
CAUSE One of the following functions has been programmed while #MCS is active:
• Zero offsets (G54-G59, G159, G92, G158, G101, G102, G53) on/off
• Fixtures on/off ("V.G.FIX" variable).
• Mirror (G11/G12/G13/G14) image on/off.
• Programming in radius/diameters (G151/G152).
• Activate incremental programming (G91).
• Programming in mm/inches (G70/G71).
• Scaling factor (G72).
• Movement in G0, G1, G2, G3, G8 or G9 in Polar coordinates.
• Threading G63 or G33 in Polar coordinates.
• Polar origin (G30).
• Pattern rotation (G73).
• Instructions #FACE, #CYL and #RTCP.
SOLUTION Check the program.
1306 'The kinematics cannot be changed while tool radius compensation is active'
DETECTION During execution.
CAUSE An attempt has been made to change the active kinematics while tool radius
compensation (G41/G42) is active.
SOLUTION Cancel tool radius compensation before changing the active kinematics.
1308 'An axis of the active transformation cannot be a slave'
DETECTION During execution.
CAUSE The #LINK instruction has been used to define an axis involved in the active
kinematics transformation as a slave of a coupling.
SOLUTION Cancel the kinematics in order to be able to activate the coupling with this axis as
a slave.
The axis involved in the active kinematics can be master of a coupling.
1309 'File name expected'
DETECTION During execution.
CAUSE It informs that no program has been selected for execution.
SOLUTION Select the program to be executed.
1310 'Program line too long'
DETECTION During execution.
CAUSE The number of characters of the block programmed in the #EXBLK instruction
exceeds the maximum allowed.
SOLUTION The maximum number of characters allowed for the block programmed with the
#EXBLK instruction is 128.
1311 'Measurement offset not included in programmed axis (axes)'
DETECTION During execution.
CAUSE An attempt has been made to exclude the measurement offset (G102) to an axis that
has no measurement offset included (G101).
SOLUTION It does not make sense to execute function G102 for an axis for which function G101
has not been executed previously.
1314 '#CS ON/#ACS ON: wrong identifier'
DETECTION During execution.
CAUSE The CS/ACS type identifier programmed in the instruction is a wrong value.
SOLUTION The CS/ACS type identifier to be activated must be a positive value, other than zero
and less than or equal to 5.
To Next Page
Loading...
