Fagor CNC8 070 - 1809 G87: Tool Diameter Smaller than C; 1810 G88: Depth = 0; 1808 G87: Tool Missing; 1807 G87: Tool Diameter = 0

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 70 of 128
Errors 1000-1999
1807 'G87: Tool diameter = 0'
DETECTION Executing a G87 pocket.
CAUSE Tool with radius 0.
SOLUTION Modify the value of the tool radius in the tool table.
1808 'G87: Tool missing'
DETECTION Executing a G87 pocket.
CAUSE Tool missing at the spindle.
SOLUTION Load a tool in the spindle before calling the cycle.
1809 'G87: tool diameter smaller than C'
DETECTION Executing a G87 pocket.
CAUSE The tool diameter is smaller than the machining pass (C) in the main plane.
SOLUTION Select a tool of larger diameter or reduce C.
1810 'G88: Depth = 0'
DETECTION Executing a G88 pocket.
CAUSE The programmed I coordinate is the same as the Z coordinate plus the D distance.
If Z has not been programmed, the I coordinate is the same as the current position
plus the D distance. This means that the pocket has no depth.
SOLUTION Modify the parameters involved I, Z and/or D.
1811 'G88: tool diameter greater than the pocket'
DETECTION Executing a G88 pocket.
CAUSE The tool radius is greater than the J dimension of the pocket.
SOLUTION Select a tool with a smaller radius.
1812 'G88: tool diameter smaller than L'
DETECTION Executing a G88 pocket.
CAUSE The tool diameter is smaller than the finishing stock L.
SOLUTION Select a tool with a larger radius.
1813 'G88: Tool diameter = 0'
DETECTION Executing a G88 pocket.
CAUSE Tool with radius 0.
SOLUTION Modify the value of the tool radius in the tool table.
1814 'G88: Tool missing'
DETECTION Executing a G88 pocket.
CAUSE Tool missing at the spindle.
SOLUTION Load a tool in the spindle before calling the cycle.
1815 'G88: tool diameter smaller than C'
DETECTION Executing a G88 pocket.
CAUSE The tool diameter is smaller than the machining pass (C) in the main plane.
SOLUTION Select a tool of larger diameter or reduce C.
1816 'The X parameter must be multiple of the I parameter'
DETECTION Executing a multiple machining cycle (G160-G165).
CAUSE The X parameter must be multiple of the I parameter.
SOLUTION Assign a correct value to the cycle parameter.
1817 'One of parameters I and K must be programmed'
DETECTION Executing a multiple machining cycle (G160-G165).
CAUSE One of the parameters I (machining pass), K (number of machining operations) has
not been programmed in a multiple machining cycle.
SOLUTION Assign a correct value to the cycle parameter.