CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 52 of 128
Errors 1000-1999
1473 '#POLY cannot be programmed while pattern rotation is active'
DETECTION During execution.
CAUSE The #POLY instruction has been programmed while the coordinate system rotation
(G73) was active.
SOLUTION Check the program.
1475 'Radius programmed twice'
DETECTION During execution.
CAUSE The radius "R" or "R1" has been programmed more than one in the same block.
SOLUTION Define only one radius in the block.
1476 'The pocket was resolved with a different tool nose (tip) radius'
DETECTION During execution.
CAUSE The pocket was generated with a tool radius other than the current one. To execute
it, it must be generated again.
SOLUTION Generate the pocket again.
1477 'The pocket was resolved with a different tool's cutting length'
DETECTION During execution.
CAUSE The pocket was generated with a tool's cutting length other than the current one. To
execute it, it must be generated again.
SOLUTION Generate the pocket again.
1478 'The pocket was resolved with a different tool entry angle'
DETECTION During execution.
CAUSE The pocket was generated with a tool entry angle other than the current one. To
execute it, it must be generated again.
SOLUTION Generate the pocket again.
1479 'G74: A subroutine has not been associated'
DETECTION During execution.
CAUSE Function G74 has been programmed alone in the block, but no subroutine associated
by machine parameter has been defined.
SOLUTION Associate a subroutine to G74 using machine parameter REFSUB.
1480 'Program: #EXEC ["path+program",channel]'
DETECTION During execution.
CAUSE The possible causes are:
• The syntax of the instruction is wrong.
• Only the block number of a label may be programmed in the same block as the
instruction.
SOLUTION In the first case, refer to the programming manual. In the second case, program in
different blocks.
1481 'Wrong channel number'
DETECTION During execution.
CAUSE A wrong channel number has been programmed in the instruction #EXEC, #MEET
or #WAIT.
SOLUTION The channel number must be between 1 and 4.
1483 'Program: #WAIT/#MEET [signal, channel, channel, ...]'
DETECTION During execution.
CAUSE The possible causes are:
• The syntax of the instruction is wrong.
• Only the block number of a label may be programmed in the same block as the
instruction.
SOLUTION In the first case, refer to the programming manual. In the second case, program in
different blocks.
To Next Page
Loading...
