Fagor CNC8 070 - 8309 Too Many Axes Have Been Programmed; 8310 Required Parameter Missing; 8311 Wrong Parameter Value; 8312 #CS;#ACS: Wrong Mode

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 118 of 128
Errors 8000-8999
8309 'Too many axes have been programmed'
DETECTION During editing.
CAUSE Too many axes have been programmed in the #POLY instruction.
SOLUTION The maximum number of axes that can be programmed is 3.
8310 'Required parameter missing'
DETECTION During editing.
CAUSE The possible causes are:
1. Some required parameter has not been programmed in the #POLY instruction.
2. Some required parameter has not been programmed in the instruction #CS DEF,
#CS ON, #CS NEW, #ACS DEF, #ACS ON or #ACS NEW.
3. Some required parameter has not been programmed in the #PROBE instruction.
SOLUTION Check the syntax of the instructions in the programming manual.
8311 'Wrong parameter value'
DETECTION During editing.
CAUSE The possible causes are:
1. A wrong value has been programmed for some argument of the instruction #CS
DEF, #CS ON, #CS NEW, #ACS DEF, #ACS ON or #ACS NEW.
2. A wrong value has been programmed for CONTERROR in the #HSC instruction.
3. A wrong value has been programmed for EP or for R in the #POLY instruction.
4. A wrong value has been programmed for the index of an arithmetic parameter.
SOLUTION Check the syntax of the instructions in the programming manual. The index of an
arithmetic parameter must always be positive or zero.
8312 '#CS/#ACS: wrong mode'
DETECTION During editing.
CAUSE A wrong value has been programmed for MODE in the instruction #CS DEF, #CS ON,
#CS NEW, #ACS DEF, #ACS ON or #ACS NEW.
SOLUTION Check the syntax of the instructions in the programming manual.
8313 '#CS/#ACS: wrong coordinate system number'
DETECTION During editing.
CAUSE A wrong value has been programmed for the coordinate system number in the
instruction #CS DEF, #CS ON, #CS NEW, #ACS DEF, #ACS ON or #ACS NEW.
SOLUTION The system number must have a value between 1 and 5, both included.
8314 'G30/G73 programmed wrong'
DETECTION During editing.
CAUSE In function G30/G73 only one of parameters I or J has been programmed.
SOLUTION Program either both parameters I and J or none of them.
8315 'Wrong probe cycle number'
DETECTION During editing and execution in MDI.
CAUSE The programmed probe cycle is wrong.
SOLUTION The right probe cycles are PROBE1 through PROBE8.
8316 'Parameter not allowed'
DETECTION During editing and execution in MDI.
CAUSE The parameter programmed for the instruction is wrong.
SOLUTION Refer to the programming manual to check the right parameters for each cycle and
instruction.
8317 'Negative D function'
DETECTION During editing.
CAUSE A negative tool offset has been programmed.
SOLUTION The tool offset must have a positive value.