CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 109 of 128
Errors 7000-7999
7041 'No tool is active'
DETECTION During execution.
CAUSE An edge has been programmed, but there is no active tool in the spindle.
SOLUTION Place a tool in the spindle.
7042 'POS has been programmed and the magazine is not in LOAD mode'
DETECTION During execution.
CAUSE A tool loading position has been programmed, but the tool manager is not in this
mode.
SOLUTION The loading position is only allowed in load mode.
7043 'The requested tool is the active tool of another channel'
DETECTION During execution.
CAUSE A tool has been programmed that is already the active tool of another channel.
SOLUTION Unload the requested tool from the spindle of the other channel, by programming T0
M6 in that channel.
To Next Page
Loading...
