CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 59 of 128
Errors 1000-1999
1535 'Program: #SETSP [sp1, sp2, ..]'
DETECTION During execution.
CAUSE The possible causes are:
• The syntax of the instruction is wrong.
• Only the block number of a label may be programmed in the same block as the
instruction.
SOLUTION In the first case, refer to the programming manual. In the second case, program in
different blocks.
1538 'A spindle cannot be restored from the channel'
DETECTION During execution.
CAUSE If a spindle that belongs to a channel has been released and it is one that must be
restored with a RESET or beginning of a program (AXISEXCH = TEMPORARY), it
may not be possible if it is being used by another channel.
SOLUTION The channel that now has the spindle must release it. Otherwise, the original channel
that the spindle belongs to will not be able to use it and it will issue a warning at each
RESET or at the beginning of a program.
1539 'Spindle name repeated in the resulting group'
DETECTION During execution.
CAUSE Using the instruction #RENAME SP, more than one spindle have been renamed with
the same name.
SOLUTION Rename each spindle with a different name so the resulting group of axes in the
channel does not have two with the same name.
1540 'Programming not allowed without a master spindle in the channel'
DETECTION During execution.
CAUSE The possible causes are:
• An attempt has been made to read or write a variable for the master spindle, but
it does not exist in the channel.
• The G function or instruction cannot be executed if there is no master spindle in
the channel.
SOLUTION Define a master spindle for the channel using the #MASTER instruction.
1541 'The spindle cannot be eliminated while the C axis is active'
DETECTION During execution.
CAUSE Using the #FREE SP or #SET SP instruction, an attempt has been made to eliminate
the spindle from the channel that is working as C axis.
SOLUTION Before removing the spindle from the channel, cancel the C axis with the #CAX OFF
instruction or activate another spindle as C axis.
1542 'The spindle cannot be exchanged'
DETECTION During execution.
CAUSE Using the instruction #CALL SP, #SET SP or #FREE SP, an attempt has been made
to change the spindle from one channel to another, but the spindle is not
exchangeable.
SOLUTION In order for the spindle to be exchangeable, set its machine parameter AXISEXCH
to TEMPORARY or MAINTAINED.
1544 'G63 and M3/M4/M5/M19/M41-M44 not allowed in the same block'
DETECTION During execution.
CAUSE No M function associated with the spindle may be programmed in the same block that
contains a rigid tapping G63.
SOLUTION It may be programmed either in the previous or next block depending on the result
to be obtained. If programmed in the next block, these M functions cancel the modal
tapping G63 in such way that G63 must be programmed again in the next movement
in order to keep tapping.
To Next Page
Loading...
