Fagor CNC8 070 - 1265 Programming Not Allowed While RTCP;TLC Is Active; 1266 The TLC Feature Is Deactivated Using the Instruction #TLC OFF; 1268 #CS ON;#ACS ON: Syntax Error; 1269 #CS ON;#ACS ON: the Programmed Angle Is Not Valid

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 33 of 128
Errors 1000-1999
1265 'Programming not allowed while RTCP/TLC is active'
DETECTION During execution.
CAUSE An attempt has been made to execute one of the following functions while RTCP or
TLC is active.
• Home search (G74).
• Modify software limits (G198 - G199).
• #OSC instruction.
• #KIN ID instruction.
SOLUTION First cancel the active incline plane, then execute the desired instructions and finally
activate the incline plane again.
1266 'The TLC feature is deactivated using the instruction #TLC OFF'
DETECTION During execution.
CAUSE While #TLC is active, a #TLC instruction other than #TLC OFF has been
programmed.
SOLUTION To program #TLC ON again to change the value programmed earlier, it must be
canceled first using #TLC OFF.
1268 '#CS ON/#ACS ON: syntax error'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
1269 '#CS ON/#ACS ON: the programmed angle is not valid'
DETECTION During execution.
CAUSE Programmed angle is not valid.
SOLUTION The angle programmed in the instruction must be within ± 360º.
1270 'The coordinate transformation cannot be calculated'
DETECTION During execution.
CAUSE An attempt has been made to make a coordinate transformation from part to machine
or from machine to part that is not solved.
SOLUTION Cancel the transformation, change the position to be accessed and activate the
transformation again.
1271 'The axes of the active kinematics can neither be excluded nor modified'
DETECTION During execution.
CAUSE Having an active kinematics, an attempt has been made to change the axes that affect
that kinematics using the instructions #CALL AX, #SET AX, #FREE AX.
SOLUTION Cancel the kinematics before changing the axes of the channel. #KIN ID [0].
1272 'The axes of the active transformation can neither be excluded nor modified'
DETECTION During execution.
CAUSE Having an active incline plane, an attempt has been made to change one of the first
three axes that affect that transformation using the instructions #CALL AX[ ], #SET
AX[ ], #FREE AX[ ].
SOLUTION Cancel the transformation of the incline plane before changing the axes of the
channel. #CS/ACS OFF ALL
1277 'The resulting zero offset exceeds the data range'
DETECTION During execution.
CAUSE The zero offset calculated from the coordinates programmed with function G92 is too
large.
SOLUTION Check the program.