CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 16 of 128
Errors 1000-1999
1075 'Incompatible G functions (G96/G97/G192)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
1077 'Incompatible G functions (G115/G116/G117)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
11079 'Incompatible G functions (G138/G139)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
1080 'Incompatible G functions (G6/G261/G262)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
1081 'Incompatible G functions (G264/G265)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
1082 'Incompatible G functions (G200/G201/G202)'
DETECTION During execution.
CAUSE Two or more G functions of the same group cannot be programmed in the same block.
SOLUTION Program them in different blocks.
1084 'Plane change not allowed while tool radius compensation is active'
DETECTION During execution.
CAUSE Function G17-G20 (plane change) has been used to change the first or second axis
of the plane while tool radius compensation was active.
SOLUTION Cancel the compensation to define the new work plane.
1085 'G41/G42 not allowed if the first or second axis of the active plane is missing'
DETECTION During execution.
CAUSE Tool radius compensation is impossible if one of the two axes of the active plane is
missing in the channel.
SOLUTION Restore the missing axis with the instruction #CALL AX or #SET AX.
1087 '"=" expected'
DETECTION During execution.
CAUSE Wrong syntax of the programmed instruction or function.
SOLUTION Refer to the programming manual. Check the program.
1088 'Wrong offset number'
DETECTION During execution.
CAUSE When programming in high level language, the wrong value is assigned to the
parameter of the G function.
SOLUTION The range of values admitted for function G159 is from 1 to 20.
1089 'Incompatible M functions (M3/M4/M5/M19)'
DETECTION During execution.
CAUSE More than one M function (M3/M4/M5/M19) have been programmed for the same
spindle in the same block.
SOLUTION Program the M functions for the same spindle in different blocks.
To Next Page
Loading...
