CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 83 of 128
Errors 2000-2999
2129 'Error in the RTCP transformation'
DETECTION During execution.
CAUSE RTCP has been programmed, but the channel does not have all the axes needed for
the transformation.
SOLUTION Before activating the RTCP, configure the channel with all the necessary axes.
2130 'Error in the incline plane transformation'
DETECTION During execution.
CAUSE An incline plane has been programmed and the channel does not have three axes.
Three axes are required for the transformation.
SOLUTION Before activating the incline plane, configure the channel with all the necessary axes.
2131 'Internal error in C axis mode'
DETECTION During execution.
CAUSE C axis transformation not possible for the block.
SOLUTION Eliminate the block that caused the error. Send the information to FAGOR.
2133 'Master axis missing'
DETECTION During execution.
CAUSE The master axis of the coupling is not available in the channel.
SOLUTION Program the coupling with axes from the channel.
2134 'Slave axis missing'
DETECTION During execution.
CAUSE The slave axis of the coupling is not available in the channel.
SOLUTION Program the coupling with axes from the channel.
2135 'Zero maximum spindle speed programmed'
DETECTION During execution.
CAUSE In constant surface speed mode, the maximum spindle speed has not been
programmed.
SOLUTION Program the maximum rpm of the spindle.
2136 'Zero maximum cutting speed programmed'
DETECTION During execution.
CAUSE In constant surface speed mode, the cutting speed has not been programmed.
SOLUTION Program the cutting speed.
2137 'FACEAXIS has not been defined'
DETECTION During execution.
CAUSE 'No face axis has been defined'
SOLUTION Set machine parameter FACEAXIS = TRUE for the face axis.
2138 'Threading axis missing'
DETECTION During execution.
CAUSE The threading axis is not in the channel.
SOLUTION Do not program a threading operation if all the axes are not available or configure the
axes of the channel to be able to make the thread.
2139 'Threading movement not programmed'
DETECTION During execution.
CAUSE No movement has been programmed for the threading axis.
SOLUTION Program the movement for the threading axis.
2140 'Wrong parameter in programming instruction #SLOPE'
DETECTION During execution.
CAUSE A parameter of the programming instruction #SLOPE is wrong.
SOLUTION Refer to the manual for the right values to program it:
#SLOPE [type(0..2), jerk(0..2), accel(0,2), mov(0,1)]
To Next Page
Loading...
