Fagor CNC8 070 - 1777 Profile: P = 0; 1778 PROFILE: (FINISHING): Tools Cutting Length < P; 1779 Slot Milling: F = 0; 1780 Slot Milling: S = 0

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 68 of 128
Errors 1000-1999
1777 'PROFILE: P = 0'
DETECTION Executing the profiling cycle.
CAUSE P (profile depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1778 'PROFILE: (FINISHING): Tool's cutting length < P'
DETECTION Executing the profiling cycle.
CAUSE The cutting length of the finishing tool defined in the tool table is smaller than the
profile depth (P) defined in the cycle.
SOLUTION Choose as the finishing tool, a tool with greater cutting length.
1779 'SLOT MILLING: F = 0'
DETECTION Executing the slot milling cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1780 'SLOT MILLING: S = 0'
DETECTION Executing the slot milling cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1781 'SLOT MILLING: T = 0'
DETECTION Executing the slot milling cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1782 'SLOT MILLING: P = 0'
DETECTION Executing the slot milling cycle.
CAUSE P (profile depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1783 'SLOT MILLING: L = 0'
DETECTION Executing the slot milling cycle.
CAUSE L (groove length) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1784 'SLOT MILLING: tool diameter smaller than DELTA'
DETECTION Executing the slot milling cycle.
CAUSE The diameter of the roughing or finishing tool is smaller than the roughing or finishing
pass in the XY plane.
SOLUTION Decrease the size of the milling pass in XY (DELTA) or machine with a tool that has
a larger diameter.
1785 'SLOT MILLING: tool diameter greater than the pocket'
DETECTION Executing the slot milling cycle.
CAUSE The diameter of the roughing or finishing tool is greater than the groove dimensions
L or H.
SOLUTION Choose a tool of a smaller diameter to make the groove.
1786 'SLOT MILLING: Finishing tool diameter smaller than delta'
DETECTION Executing the slot milling cycle.
CAUSE The diameter of the finishing tool is smaller than the finishing stock in the XY plane
(delta).
SOLUTION Choose a tool of a greater diameter to make the slot.
1787 'CIRCULAR POCKET: F = 0'
DETECTION Executing circular pocket cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.