Fagor CNC8 070 - 8254 Too Many Axes in G20; 8256 Nonexistent Interpolator Cycle Instruction; 8257 There Can be Nothing after Name of the Program or Subroutine; 8258 Expression Expected after #TIME

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 115 of 128
Errors 8000-8999
8254 'Too many axes in G20'
DETECTION During editing.
CAUSE Some of the parameters programmed for G20 are not allowed.
SOLUTION Check the G20 programming syntax.
8256 'Nonexistent interpolator cycle instruction'
DETECTION During editing and execution in MDI.
CAUSE The programmed instruction does not exist.
SOLUTION Refer to the programming manual.
8257 'There can be nothing after the name of the program or subroutine'
DETECTION During editing.
CAUSE The possible causes are:
1. In the block defining the name of the main program or subroutine, other characters
have also been written.
2. The name of the main program or subroutine has a blank space.
SOLUTION The definition of the main program or subroutine can only be accompanied by a
comment. The forbidden characters are:
1. Main program: \ / : * ? " < > | and blank space.
2. Local subroutine: / ? " < > | ) and blank space.
8258 'Expression expected after #TIME'
DETECTION During editing and execution in MDI.
CAUSE The #TIME instruction has been programmed incorrectly.
SOLUTION The dwell may be programmed in two ways with the instruction #TIME:
• #TIME [<expression>]
• #TIME [<expression>]
The parameter <expression> may be a whole number (integer), an arithmetic
parameter or a control variable.
8265 'Unknown or incomplete word'
DETECTION During editing.
CAUSE The possible causes are:
1. The programmed function, instruction or expression is not valid.
2. M function has been programmed wrong for a particular spindle.
3. #TOOL AX instruction programmed wrong.
SOLUTION Refer to the programming manual to check the syntax of the instruction, function or
expression to be programmed.
8267 'Cycle variable without writing permission'
DETECTION During editing.
CAUSE An attempt has been made to write a cycle variable that does not have a writing
permission.
SOLUTION The variable can only be read.
8275 'Too many M functions in the same block'
DETECTION During editing.
CAUSE Too many M functions in the same block.
SOLUTION The maximum number of M functions allowed in the same block is 7.
8276 'Too many H functions in the same block'
DETECTION During editing.
CAUSE Too many H functions in the same block.
SOLUTION The maximum number of H functions allowed in the same block is 7.