CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 105 of 128
Errors 7000-7999
ERRORS 7000-7999
7001 'Two consecutive T's in cyclic magazine (M6 required)'
DETECTION During execution.
CAUSE Cyclic magazine and two consecutive T's have been programmed.
SOLUTION Program an M6 after each T.
7002 'The tool is not in the magazine and ground tools are not allowed'
DETECTION During execution.
CAUSE A tool has been programmed that is in the tool table, but it is not in the magazine table.
In this case the tool is assumed to be a ground tool, but the machine parameter
indicates that ground tools are not allowed.
SOLUTION Change the machine parameter to accept ground tools.
7003 'T not defined in the table'
DETECTION During execution.
CAUSE A tool has been programmed that is not defined in the tool table.
SOLUTION Define a tool.
7004 'Tool rejected or worn out (expired)'
DETECTION During execution.
CAUSE A ground tool has been programmed but it is either expired (worn out) or invalid.
SOLUTION Program an equivalent tool that is neither expired nor rejected.
7005 'Tool rejected or expired and without replacement'
DETECTION During execution.
CAUSE A tool has been programmed that is either worn out (expired) or invalid. When
searching for a tool of the same family, there is none available.
SOLUTION Enable a tool of the same family so it can be used.
7006 'D not allowed for this tool'
DETECTION During execution.
CAUSE An invalid edge has been programmed. The tool has less edges than the one
programmed.
SOLUTION Define the necessary edges on the tool.
7007 'In load mode: T0 not admitted'
DETECTION During execution.
CAUSE T0 cannot be programmed when the magazine is in load mode.
SOLUTION Program the T to be loaded.
7008 'In load mode: this tool is already loaded'
DETECTION During execution.
CAUSE While the tool is load mode, a tool has been programmed that is already in the
magazine.
SOLUTION Program a tool that is not loaded yet.
To Next Page
Loading...
