Fagor CNC8 070 - 7009 In Load Mode: M6 Without T; 7010 In Load Mode: T with Two M6; 7011 In Load Mode: D Alone Not Allowed; 7012 In Load Mode: the Tool Is Either Worn out (Expired) or Rejected

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 106 of 128
Errors 7000-7999
7009 'In load mode: M6 without T'
DETECTION During execution.
CAUSE In load mode, an M6 has been programmed without the corresponding T.
SOLUTION First, program a T with the tool to be loaded.
7010 'In load mode: T with two M6'
DETECTION During execution.
CAUSE In load mode, a second M6 has been detected for the same T.
SOLUTION Program the T's and the M6's in sequence.
7011 'In load mode: D alone not allowed'
DETECTION During execution.
CAUSE A "D" cannot be programmed alone in load mode.
SOLUTION It cannot be programmed like this.
7012 'In load mode: The tool is either worn out (expired) or rejected'
DETECTION During execution.
CAUSE In load mode, the tool to be loaded is either worn out (expired) or rejected.
SOLUTION Program another tool that is available.
7013 'In load mode: Wrong position or there is no room in the magazine'
DETECTION During execution.
CAUSE In load mode, it has been detected that either the magazine is full or the indicated
position is occupied.
SOLUTION If there is no room in the magazine, first unload a tool. If the indicated position is
occupied, choose another one.
7014 'In unload mode: T is not in the magazine'
DETECTION During execution.
CAUSE While the magazine is in unload mode, a tool has been programmed that is not in
the magazine.
SOLUTION A tool that is not loaded cannot be unloaded.
7015 'In unload mode: D not allowed with T'
DETECTION During execution.
CAUSE The D cannot be programmed in unload mode.
SOLUTION Remove the D from the programming instruction.
7016 'In unload mode: D alone not allowed'
DETECTION During execution.
CAUSE A "D" cannot be programmed alone in unload mode.
SOLUTION It cannot be programmed like this.
7017 'In unload mode: M6 without T'
DETECTION During execution.
CAUSE In unload mode, an M6 has been programmed without the corresponding T.
SOLUTION First, program a T with the tool to be unloaded.
7018 'In unload mode: T with two M6'
DETECTION During execution.
CAUSE In load mode, a second M6 has been detected for the same T.
SOLUTION Program the T's and the M6's in sequence.
7019 'In Setting: T0 not admitted'
DETECTION During execution.
CAUSE In Setting mode, the tool T0 is not valid
SOLUTION Program a tool other than 0.