Fagor CNC8 070 - 1278 G131;G133: Wrong Value; 1281 The Number of Parameters and Format Indicators Do Not Match; 1282 Message too Long; 1283 Too Many Format Indicators

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 34 of 128
Errors 1000-1999
1278 'G131/G133: wrong value'
DETECTION During execution.
CAUSE The possible causes are:
• Function G131 has been used to program the wrong value for the percentage of
acceleration to be applied to the axes.
• Function G133 has been used to program the wrong value for the percentage of
jerek to be applied to the axes.
SOLUTION The percentage of acceleration or jerk to apply to the axes must be positive and less
than or equal to 100%.
1279 '" expected'
DETECTION During execution.
CAUSE Quote marks are missing in the programmed expression or instruction.
SOLUTION Check the syntax of the programmed block.
1281 ''The number of parameters and format indicators do not match'
DETECTION During execution.
CAUSE The number of format indicators (%D or %d) appearing in the #MSG or #WARNING
instruction does not match the number of parameters to be displayed in the message.
SOLUTION Check the syntax of the instruction in the programming manual.
1282 'Message too long'
DETECTION During execution.
CAUSE A message of more than 69 characters has been programmed in the instruction
#MSG, #ERROR, #WARNING.
SOLUTION Reduce the number of characters in the message considering that the maximum is
69. This limit also includes the characters that would replace the possible indicators.
1283 'Too many format indicators'
DETECTION During execution.
CAUSE More than 5 format indicators (%D ó %d) have been programmed in the instruction
#MSG, #ERROR, #WARNING.
SOLUTION Reduce the number of format indicators programmed.
1284 'Arithmetic expression expected'
DETECTION During execution.
CAUSE Format indicators (%d - %D) have been programmed in the instruction #MSG,
#WARNING, #ERROR, but the list of values to be displayed has not been
programmed.
SOLUTION Program the list of values to be displayed in the instruction.
Check the syntax of the instruction in the programming manual.
1285 'Tool radius written twice'
DETECTION During execution.
CAUSE The writing of the tool radius has been programmed more than once in the same
block.
SOLUTION Program only once in the block the writing of the tool radius.
1286 'Tool length written twice'
DETECTION During execution.
CAUSE The writing of the tool length has been programmed more than once in the same
block.
SOLUTION Program only once in the block the writing of the tool length.
1287 '"[" expected'
DETECTION During execution.
CAUSE The opening bracket is missing in the programmed expression or instruction.
SOLUTION Check the syntax of the programmed block.