Fagor CNC8 070 - 1709 Drilling 1: P = 0; 1710 Drilling 2: F = 0; 1711 Drilling 2: S = 0; 1712 Drilling 2: T = 0

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 62 of 128
Errors 1000-1999
1709 'DRILLING 1: P = 0'
DETECTION Executing drilling cycle 1.
CAUSE P (depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1710 'DRILLING 2: F = 0'
DETECTION Executing drilling cycle 2.
CAUSE F programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1711 'DRILLING 2: S = 0'
DETECTION Executing drilling cycle 2.
CAUSE S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1712 'DRILLING 2: T = 0'
DETECTION Executing drilling cycle 2.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a tool T.
1713 'DRILLING 2: P = 0'
DETECTION Executing drilling cycle 2.
CAUSE P (depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1714 'DRILLING 2: B = 0'
DETECTION Executing drilling cycle 2.
CAUSE B (drilling peck) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1715 'THREADING: F = 0'
DETECTION Executing the threading cycle.
CAUSE F programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1716 'THREADING: S = 0'
DETECTION Executing the threading cycle.
CAUSE S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1717 'THREADING: T = 0'
DETECTION Executing the threading cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a tool T.
1718 'THREADING: P = 0'
DETECTION Executing the threading cycle.
CAUSE P (depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1719 'REAMING: F = 0'
DETECTION Executing the reaming cycle.
CAUSE F programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1720 'REAMING: S = 0'
DETECTION Executing the reaming cycle.
CAUSE S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.