Fagor CNC8 070 - 1292 M Function Programmed Twice; 1288 Too Many Parameters Programmed in the Instruction; 1291 No more S Functions Allowed; 1290 I, J, K Coordinates Programmed Wrong

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 35 of 128
Errors 1000-1999
1288 'Too many parameters programmed in the instruction'
DETECTION During execution.
CAUSE The instruction has not been programmed correctly.
SOLUTION Check the syntax of the instruction in the programming manual.
1290 'I, J, K coordinates programmed wrong'
DETECTION During execution.
CAUSE The probable causes are:
• The programmed values for the center of the circular interpolation, Polar origin
or center of rotation of the coordinate system are too high.
• Wrong values have been programmed for the coordinates of the center of the
circular interpolation being G264 active.
SOLUTION Check the program.
1291 'No more S functions allowed'
DETECTION During execution.
CAUSE The maximum number of S functions allowed in the same block has been exceeded.
SOLUTION The maximum number of S functions allowed in the same block is 4.
1292 'M function programmed twice'
DETECTION During execution.
CAUSE An M function that is not related with the spindle has been programmed more than
once in the same block.
SOLUTION Program them in different blocks.
1293 'H function programmed twice'
DETECTION During execution.
CAUSE An H function has been programmed more than once in the same block.
SOLUTION Program them in different blocks.
1301 'The tool length transformation exceeds the valid numeric format'
DETECTION During execution.
CAUSE The maximum numeric format has been exceeded in the tool length transformation.
SOLUTION Modify the values of the transformation or those of the tool.
1302 'Wrong character in the name'
DETECTION During execution.
CAUSE The possible causes are:
1. Wrong character in the name of a label.
2. Wrong character in the name of a subroutine.
3. Wrong character in the name of an external variable.
SOLUTION Valid characters in each one of the previous cases:
1. All except quotes, "]" and tab.
2. All except quotes, blank space and tab. All characters after the "(" will be
considered as part of the comment.
3. letters, digits and the "_" character.
1303 'Variable name too long'
DETECTION During execution.
CAUSE Defining "part" as each set of characters separated by "." in the name of a variable,
the error comes up when a part has more than 13 characters.
SOLUTION Shorten the name of the variable.
1304 'Wrong spindle speed'
DETECTION During execution.
CAUSE The programmed spindle speed value is too low.
SOLUTION The value of the spindle speed must be higher than 1.6 10E-7 rpm.