CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 86 of 128
Errors 3000-3999
3011 'Too many axis programmed as probe'
DETECTION When executing a probing block.
CAUSE The number of axes programmed in the probing process exceeds the maximum
number of axes of the channel.
SOLUTION Modify the probing block.
3013 'Braking distance greater than parameter PROBERANGE'
DETECTION During execution.
CAUSE The distance needed to brake at the current speed is greater than parameter
PROBERANGE.
SOLUTION Increase the braking distance (PROBERANGE), or decrease the probing feedrate.
3015 'During block search, the home search is left out'
DETECTION During execution.
CAUSE An attempt has been made to search home while executing in dry run.
SOLUTION Search home outside the program.
3016 'During the block search, the manual mode is left out'
DETECTION During execution.
CAUSE A manual mode request has been received during block search.
SOLUTION Do not try to make a manual mode request during block search or bear in mind the
warning that the manual mode is not active.
3017 'Block search already activated'
DETECTION During block search.
CAUSE An attempt has been made to activate block search, but it was already activated.
SOLUTION Contact your supplier.
3018 'The constant surface speed has not been reached yet'
DETECTION During execution.
CAUSE The spindle has not reached the programmed speed.
SOLUTION The solutions may be:
• Decrease the constant surface speed S.
• Decrease the axis feedrate.
• Program S before and give the spindle some time to catch up speed.
3019 'The feedrate programmed in G95 is too low'
DETECTION During execution.
CAUSE The resulting feedrate is too low.
SOLUTION Increase the feedrate or increase the spindle rpm.
3020 'S has not been programmed in G96'
DETECTION During execution.
CAUSE The spindle speed is zero.
SOLUTION Program a speed.
3021 'The maximum constant surface speed is zero'
DETECTION During execution.
CAUSE The maximum spindle speed is zero.
SOLUTION Program a speed.
3022 'Error when initializing the coordinates of the axes'
DETECTION During execution.
CAUSE The coordinates of an axis do not match.
SOLUTION Contact your Fagor supplier.
3023 'Axes missing in the new coordinate system'
DETECTION During execution.
CAUSE While defining the new coordinate system, one of the first three axes of the channel
is not active.
SOLUTION Activate the desired first three axes of the channel using the instruction #SET AX[ ].
To Next Page
Loading...
