CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 85 of 128
Errors 3000-3999
ERRORS 3000-3999
3000 'An arc cannot be programmed with a slave axis'
DETECTION During execution.
CAUSE The possible causes are:
1. An attempt has been made to separately move an axis that is coupled to another
axis.
2. An attempt has been made to separately move an axis that is associated as
Gantry to another axis.
SOLUTION A slave axis cannot move separately. To move a slave axis, move the master axis it
is associated with.
3001 'An axis cannot be moved in DRO mode'
DETECTION During execution.
CAUSE An attempt has been made to move an axis that is in DRO mode.
SOLUTION Do not try to move a DRO axis or set the axis so it is no longer a DRO axis.
3002 'Positive software travel limit overrun'
DETECTION While repositioning an axis.
CAUSE An attempt has been made to reposition the axis at a point that is beyond the software
limits. It is not possible to reach the point to resume the execution of the program.
SOLUTION Keep the axes within the software limits.
3003 'Negative software travel limit overrun'
DETECTION While repositioning an axis.
CAUSE An attempt has been made to reposition the axis at a point that is beyond the software
limits. It is not possible to reach the point to resume the execution of the program.
SOLUTION Keep the axes within the software limits.
3005 'Error of the position control when initializing the probing process'
DETECTION When initializing the probing process
CAUSE It is an enabling safety feature of the probing process in all the programmed axes.
The programmed axes are not valid or are not available.
SOLUTION Check that the programmed axes are valid and available.
3007 'The probe signal has been received before the movement'
DETECTION After detecting the probe signal.
CAUSE Probing process enabled without having programmed G100.
SOLUTION Contact your supplier.
3008 'Error in the probing process'
DETECTION After detecting the probe signal.
CAUSE It is an enabling safety feature of the probing process in all the programmed axes.
SOLUTION Check that the programmed axes are valid and available.
3010 'The axis has not been defined as probe (PROBEAXIS)'
DETECTION During execution.
CAUSE An attempt has been made to probe with an axis that is not defined as an axis involved
in the probing movement.
SOLUTION Change the parameter PROBEAXIS of the axis to probe with.
To Next Page
Loading...
