CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 32 of 128
Errors 1000-1999
1256 'Acceleration percentage out of range'
DETECTION During execution.
CAUSE The acceleration percentage programmed with function G130 is too high.
SOLUTION The maximum value allowed for the acceleration percentage is 2147483646.
1257 'The leadscrew pitch has been programmed twice'
DETECTION During execution.
CAUSE Using function G33, the thread pitch has been programmed more than once in the
block.
SOLUTION Define the thread pitch only once in the block.
1258 'Leadscrew pitch equal to zero'
DETECTION During execution.
CAUSE The thread pitch programmed with function G33 is zero.
SOLUTION Program the thread pitch with letters I, J, K being each one associated with the axes
X, Y, Z respectively.
Check the syntax of the instruction in the programming manual.
1259 'Leadscrew pitch out of range'
DETECTION During execution.
CAUSE The thread pitch value programmed with function G33 is too high.
SOLUTION Program a smaller value for the thread pitch.
1261 'Unknown kinematics type'
DETECTION During execution.
CAUSE An attempt has been made to activate #RTCP, or #TLC, or #CS/ACS in mode 6
without having a kinematics active.
SOLUTION First activate the kinematics and then the transformation.
#KIN ID [ ]
#RTCP ON or #TLC ON [ ] or #CS/ACS ON [MODE6, , , , ]
1262 'The group of the axes is not enough for the transformation'
DETECTION During execution.
CAUSE The coordinate transformation #RTCP, or #TLC, or #CS/ACS needs a number of
active axes and they must be the first ones of the channel. This number of active axes
must be between 3 and 5 depending on the type of kinematics active.
SOLUTION Activate the axes on to which to apply the transformation in the first positions of the
channel using a #SET AX [ , , , , ]
1263 'Rotary axis (axes) missing for the transformation'
DETECTION During execution.
CAUSE The instruction #TOOL ORI has been programmed, but there is no rotary axis to place
the tool perpendicular to the defined incline plane.
SOLUTION Either do not program the instruction #TOOL ORI or activate the kinematics that
allows placing the tool perpendicular to the defined incline plane.
1264 'Programming not allowed while CS/ACS is active'
DETECTION During execution.
CAUSE An attempt has been made to execute one of the following functions while CS or ACS
is active.
• Home search (G74).
• Modify software limits (G198 - G199).
• Execute the probing cycle #PROBE1.
• #OSC instruction.
• #LINK instruction.
• #ECS instruction.
SOLUTION First cancel the active incline plane and then execute the desired instructions. Finally,
activate the incline plane again.
To Next Page
Loading...
