CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 60 of 128
Errors 1000-1999
1545 'Spindle gear change is not possible while G63 or #CAX is active'
DETECTION During execution.
CAUSE The spindle gear change is not possible while tapping G63 is active or while working
as C axis.
SOLUTION Cancel G63 or #CAX, change the gear and activate functions G63 or #CAX again
if so wished.
1546 'G63 not allowed without prior gear at the spindle'
DETECTION During execution.
CAUSE This situation is only possible if after a system power-up or a reset, the PLC does not
indicate any gear with GEAR1/2/3/4 for that particular spindle. Then, there is no
spindle gear and if the spindle is not used before programming G63, it won't be
generated automatically, either.
SOLUTION Before starting a G63 tapping, the spindle must have a gear activated. Generate or
program a spindle gear before activating G63.
• Directly using functions M41-M44.
• If the spindle is "AUTOGEAR" the gear is also generated when programming a
speed (S).
• If the spindle is not "AUTOGEAR", the gear may be generated by programming
a speed (S) and M3 or M4.
1547 '#CAX not allowed while G63 is active'
DETECTION During execution.
CAUSE A spindle cannot be activated as C axis if it is being used by function G63.
SOLUTION Cancel G63 before programming #CAX or use another spindle of the channel for the
C axis.
1548 'The master spindle cannot be changed while G33/G63/G95/G96 are active'
DETECTION During execution.
CAUSE Function G63 and G96 use the master spindle of the channel. This one cannot be
removed from the channel while these functions are active.
SOLUTION Cancel G63 or G96 before releasing the spindle.
1549 'Null or wrong pocket name'
DETECTION During execution.
CAUSE When a 2D or 3D pocket has been defined with the cycle editor, the pocket name has
not been defined or its name is wrong. The pocket name cannot be #DATAP2D or
#DATAP3D generated by the cycle editor.
SOLUTION Assign a different name to the pocket.
1550 'Two C axes cannot be programmed in the same channel'
DETECTION During execution.
CAUSE The C axis feature may be activating using any spindle of the channel, but not
simultaneously with more than one of them.
SOLUTION Cancel #CAX on a spindle before activating it for another one.
1551 'Too many local parameter nesting levels'
DETECTION During execution.
CAUSE The nesting of subroutine calls with #PCALL or with function G1-G190 increases the
nesting level of the local parameters. The error comes up because the maximum
nesting level (7) of local parameters has been exceeded.
SOLUTION Decrease the nesting of subroutines or use the instructions #CALL, L or LL to call
them; they do not increase the nesting level of local parameters.
1552 'The name of the variable must begin with a "V."
DETECTION During execution.
CAUSE The name of a variable has been written from a part program or MDI without the
starting prefix "V."
SOLUTION Add the prefix "V." to the name of the variable.
To Next Page
Loading...
