Fagor CNC8 070 - 1005 Motion Block with Zero Feedrate; 1000 Function of Instruction Requires Programming the Axes; 1004 Zero Spindle Speed; Errors 1000-1999

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 9 of 128
Errors 1000-1999
ERRORS 1000-1999
1000 'The function of instruction requires programming the axes'
DETECTION During execution.
CAUSE The axes affected by the programmed instruction or G function have not been
programmed.
SOLUTION Check the program.
1004 'Zero spindle speed'
DETECTION During execution.
CAUSE Being function G63 active, a zero spindle speed has been programmed.
SOLUTION Program the spindle speed S.
1005 'Motion block with zero feedrate'
DETECTION During execution.
CAUSE No feedrate (F) has been programmed to move the axes.
SOLUTION Program the feedrate F.
1006 'G20: spindle not allowed'
DETECTION During execution.
CAUSE Function G20 does not allow programming of the spindle.
SOLUTION Check the program.
1007 'The programmed function requires a nonexistent main axis'
DETECTION During execution.
CAUSE The following functions require the existence of both axes of the main plane:
• G2, G3, G8, G9, G30, G36, G37, G38, G39 and G73.
• G20 if collision detection is active.
• Activate collision detection, G20.
The following functions require the existence of one of the two axes of the main plane:
G11, G12, G13 and G14.
SOLUTION Check the program.
1008 'Coordinates out of range'
DETECTION During execution.
CAUSE The possible causes are:
• Using function G101, an attempt has been made to include in the axis a
measuring offset too large.
• The coordinate programmed for the axis is too large.
SOLUTION Check the program.
1009 'G4: the dwell has been programmed twice, directly and using K'
DETECTION During execution.
CAUSE The dwell G4 has been programmed twice in the same block, directly with a number
and with K.
SOLUTION Program the dwell function G4 only once.