CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 90 of 128
Errors 3000-3999
3606 'The spindle positioning requires an absolute coordinate'
DETECTION During execution.
CAUSE After a spindle turn in open loop, the positioning must always be in absolute
coordinates.
SOLUTION Program the positioning in absolute coordinates.
3700 'Axis travel limit overrun'
DETECTION During the movement of the axis.
CAUSE An attempt has been made to overrun the physical travel limits (PLC).
SOLUTION Check the program.
3701 'The reference position is beyond the software limits'
DETECTION During the validation of machine parameters.
CAUSE The value of parameter REFVALUE exceeds the range of the axis software limits.
SOLUTION Change the parameters involved.
3702 'Axis following error out of limit'
DETECTION During execution.
CAUSE The values allowed for the following error and set by machine parameter have been
exceeded. Possible causes: Improper axis adjustment, some enable is missing,
failures in the motor, drive, feedback system and/or mechanical.
SOLUTION Check parameters, adjustment, connections, status of the drive, feedback system,
motor,
3703 'Positive software travel limit overrun'
DETECTION During the movement of the axis.
CAUSE The coordinate set by machine parameter LIMITPOS or by variable RTLIMITPOS has
been exceeded.
SOLUTION Check the program.
3704 'Negative software travel limit overrun'
DETECTION During the movement of the axis.
CAUSE The coordinate set by machine parameter LIMITPOS or by variable RTLIMITPOS has
been exceeded.
SOLUTION Check the program.
3705 'Home search required'
DETECTION When positioning the spindle if it has not been homed.
CAUSE The spindle reference (home) got lost when switching from open loop to close loop.
SOLUTION Contact your supplier.
3706 'Error when operating with a probe'
DETECTION Error when initializing the probing process.
CAUSE The digital input assigned to the probe is not valid.
SOLUTION Check the probe parameters.
3707 'Error when searching home'
DETECTION In the home search process for analog and sercos axes.
CAUSE Reported by the CAN counter and the Sercos drive when the home search process
fails. It may be due to wrong parameter settings or a faulty counter, sercos drive,
feedback system, connections, etc.
SOLUTION Check the parameters related with home search, status of the counter module or
sercos drive, feedback system, connections, etc.
3708 'Maximum time to get into the in-position zone exceeded'
DETECTION During the movement of an axis.
CAUSE The time to reach position is greater than the value set by parameter INPOMAX.
SOLUTION Adjust parameter INPOMAX.
To Next Page
Loading...
