CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 76 of 128
Errors 1000-1999
1870 'Pocket with islands: Wrong finishing S'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The spindle speed (S) programmed for the finishing operation has a value of 0.
SOLUTION Program S with a value other than 0.
1871 'Pocket with islands: Wrong roughing pass'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The machining pass (D) programmed in the roughing operation is greater than the
tool diameter.
SOLUTION Program a roughing pass value less than or equal to the tool diameter.
1872 'Pocket with islands: Wrong finishing pass'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The machining pass (D) programmed in the finishing operation at the bottom of the
2D pocket is greater than the tool diameter. Or the finishing pass (e) in 3D pockets
has been programmed with a value of 0.
SOLUTION Program the correct value in the corresponding case.
1873 'Pocket with islands: Wrong side stock (excess material)'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The value of the side stock (d) programmed for the finishing operation is greater than
the diameter of the tool to be used for that operation.
SOLUTION Program a side stock less than or equal to the tool diameter.
1874 'Pocket with islands: Wrong depth'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The value of the programmed pocket depth (P) is 0.
SOLUTION Program it with a value other than 0.
1875 'Pocket with islands: XY profile does not exist'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The programmed XY profile does not exist.
SOLUTION Change the name of the profile with an existing one or generate the programmed
profile.
1876 'Pocket with islands: Wrong XY profile'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE Geometry of the XY profile programmed wrong.
SOLUTION Enter the profile editor to edit the profile and check what part of the geometry is
programmed wrong.
1877 'Pocket with islands: Z profile does not exist'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The programmed Z profile does not exist.
SOLUTION Change the name of the profile with an existing one or generate the programmed
profile.
1878 'Pocket with islands: Wrong finishing tool tip (nose) radius'
DETECTION Execution of a 3D pocket cycle with islands.
CAUSE The tip radius (Rp) of the finishing tool is greater than its radius ( R ).
SOLUTION Program a tool tip radius smaller than or equal to the radius.
1879 'Pocket with islands: Wrong semi-finishing tool radius'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The possible causes are:
• The radius of the finishing tool for the bottom of 2D pockets has a value of 0 or
it is too large for the geometry of the pocket.
• The radius of the semi-finishing tool in 3D pockets has a value of 0.
SOLUTION Program the correct value in the corresponding case.
To Next Page
Loading...
