Fagor CNC8 070 - 1828 360 Must be Multiple of Parameter I; 1830 Tool Diameter = 0; 1831 G82: C = 0; 1833 FINISHING: N = 0 and Undefined Tools Cutting Length.

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 72 of 128
Errors 1000-1999
1828 '360 must be multiple of parameter I'
DETECTION Executing a multiple machining cycle in circle (G163).
CAUSE The angular pass (I) must be multiple of 360º.
SOLUTION Assign a correct value to the cycle parameter.
1829 'I = 0'
DETECTION Executing a multiple machining canned cycle (G160-G165).
CAUSE Parameter I (distance between consecutive machining passes) has been assigned
a value of 0.
SOLUTION Assign a value other than 0.
1830 'Tool diameter = 0'
DETECTION It does not exist.
CAUSE The diameter of the tool used to execute the cycle is 0.
SOLUTION Assign a value other than 0 to the tool diameter.
1831 'G82: C = 0'
DETECTION Execution of the canned cycle G82.
CAUSE The C parameter of that cycle has been programmed with a value of 0. The C
parameter indicates up to what distance of the previous drilling peck it will move in
rapid before doing the next peck.
SOLUTION Assign to C a value other than 0.
1832 'ROUGHING: I = 0'
DETECTION Executing a canned cycle.
CAUSE The I parameter (maximum penetrating pass) has been defined with a value of 0.
SOLUTION Assign to I a value other than 0 and less than the roughing tool's cutting length.
1833 'FINISHING: N = 0 and undefined tool's cutting length.
DETECTION Executing a canned cycle.
CAUSE N (number of finishing passes) has been programmed with a value of 0 and the cutting
length of the finishing tool has not been defined.
SOLUTION Program the N value.
1834 'FINISHING: Z delta greater than the tool's cutting length'
DETECTION Executing a canned cycle.
CAUSE The cycle parameter dz (penetrating stock or excess material) has been programmed
with a value greater than the cutting length of the finishing tool.
SOLUTION Program a smaller dz or use another tool.
1835 'Pocket with islands: Wrong safety Z'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The safety Z (Zs) is programmed inside the part.
SOLUTION Program it outside the part.
1836 'Pocket with islands: Wrong Z profile'
DETECTION Execution of a 3D pocket cycle with islands.
CAUSE One of the programmed profiles in Z cannot be machined.
SOLUTION Check that the profiles in Z can be machined.
1837 'Pocket with islands: Profile in XY intersects itself'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE One of the profiles in XY forms more than one closed profile.
SOLUTION Check that the profiles in XY only have one point in common, that is precisely its
starting point.
1838 'Pocket with islands: The XY profile is not closed'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE One of the XY profiles is not a closed profile; in other words, its initial and final points
are not the same.
SOLUTION Check that all the profiles in the plane are closed.