CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 81 of 128
Errors 2000-2999
2101 'Negative software limit overrun in G5-G60'
DETECTION During execution.
CAUSE The path generated by the CNC to round the corner is out of the active travel limits.
SOLUTION Program without G50 or G7 rounding .
2102 'Programming instruction #ROUNDPAR with parameter too small'
DETECTION During execution.
CAUSE The error parameter is too small to be processed.
SOLUTION Program the instruction with a value greater than 20 microns.
2103 'Programming instruction #ROUNDPAR with the wrong type of parameter'
DETECTION During execution.
CAUSE The type programmed for rounding is wrong.
SOLUTION Program valid values according to the manual.
2106 'Internal error in HSC mode'
DETECTION During execution.
CAUSE An error has occurred when calculating the path to work in HSC mode.
SOLUTION Cancel the HSC mode in the blocks causing the error.
2108 'HSC mode change not allowed'
DETECTION During execution.
CAUSE It has been programmed in HSC mode while another one was active.
SOLUTION Cancel the HSC mode before programming another one.
2109 'HSC: Contour error too small'
DETECTION During execution.
CAUSE The contour error is too small to be processed.
SOLUTION Program the instruction with a value greater than 20 microns.
2110 'Positive software limit overrun in HSC mode'
DETECTION During execution.
CAUSE The path generated by the CNC to work in HSC mode is out of the active travel limits.
SOLUTION Cancel the HSC mode in the block or blocks that cause the error.
2111 'Negative software limit overrun in HSC mode'
DETECTION During execution.
CAUSE The path generated by the CNC to work in HSC mode is out of the active travel limits.
SOLUTION Cancel the HSC mode in the block or blocks that cause the error.
2112 'Undetermined initial tangent in spline'
DETECTION During execution.
CAUSE Either the starting point is not the same as the previous one, thus the tangent is
undetermined or only one axis of the tangent has been programmed.
SOLUTION Program a prior entry point to the spline.
2113 'Undetermined final tangent in spline'
DETECTION During execution.
CAUSE Either the final point is not the same as the previous one, thus the tangent is
undetermined or only one axis of the tangent has been programmed.
SOLUTION Program an exit point after the spline.
2114 'Spline activating command not allowed'
DETECTION During execution.
CAUSE The spline mode activation has been programmed without finishing a previous spline.
SOLUTION Cancel a spline mode before defining a new one.
2115 'Programming instruction #ASPLINE with wrong parameter'
DETECTION During execution.
CAUSE The type of tangency is wrong.
SOLUTION Program one of the types indicated in the manual.
To Next Page
Loading...
