Fagor CNC8 070 - 1736 Rectangular Pocket: S = 0; 1733 Boring 2: T = 0; 1735 Rectangular Pocket: F = 0; 1734 Boring 2: P = 0

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 64 of 128
Errors 1000-1999
1733 'BORING 2: T = 0'
DETECTION Executing boring cycle 1.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a tool T.
1734 'BORING 2: P = 0'
DETECTION Executing boring cycle 1.
CAUSE P (depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1735 'RECTANGULAR POCKET: F = 0'
DETECTION Executing rectangular pocket cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1736 'RECTANGULAR POCKET: S = 0'
DETECTION Executing rectangular pocket cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1737 'RECTANGULAR POCKET: T = 0'
DETECTION Executing rectangular pocket cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1738 'RECTANGULAR POCKET: P = 0'
DETECTION Executing rectangular pocket cycle.
CAUSE P (pocket depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1739 'RECTANGULAR POCKET: tool diameter smaller than DELTA'
DETECTION Executing rectangular pocket cycle.
CAUSE The diameter of the roughing or finishing tool is smaller than the roughing or finishing
pass in the main plane.
SOLUTION Decrease the size of the milling pass in XY (DELTA) or machine with a tool that has
a larger diameter.
1740 'RECTANGULAR POCKET: tool diameter greater than the pocket'
DETECTION Executing rectangular pocket cycle.
CAUSE The diameter of the roughing or finishing tool is greater than the pocket dimensions
L or H.
SOLUTION Choose a tool of a smaller diameter to make the pocket.
1741 'RECTANGULAR POCKET: Finishing tool diameter smaller than delta'
DETECTION Executing rectangular pocket cycle.
CAUSE The diameter of the finishing tool is smaller than the finishing stock in the main plane
(delta).
SOLUTION Choose a tool of a larger diameter to make the pocket.
1742 'PRE-EMPTIED POCKET: F = 0'
DETECTION Executing pre-emptied pocket cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1743 'PRE-EMPTIED POCKET: S = 0'
DETECTION Executing pre-emptied pocket cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.