CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 77 of 128
Errors 1000-1999
1880 'Pocket with islands: Semi-finishing T missing'
DETECTION Execution of a 3D pocket cycle with islands.
CAUSE The tool number (T) programmed in the semi-finishing operation does not exist in the
tool table.
SOLUTION Insert the tool in the table or program another tool number that is in the table.
1881 'Pocket with islands: Wrong semi-finishing F'
DETECTION Execution of a 3D pocket cycle with islands.
CAUSE The machining feedrate (F) programmed for the semi-finishing operation has a value
of 0.
SOLUTION Program F with a value other than 0.
1882 'Pocket with islands: Wrong semi-finishing S'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The spindle speed (S) programmed for the semi-finishing operation has a value of 0.
SOLUTION Program S with a value other than 0.
1883 'Pocket with islands: Pocket already in execution'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE A 2D or 3D pocket cannot be simulated or executed because it is already in execution
or simulation.
SOLUTION Wait for it to end, to execute it again.
1884 'Pocket with islands: Arc programmed wrong in the profile'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE An arc of one of the profiles making up the geometry of the pocket is programmed
wrong. This could be due to the following causes:
• It has not been edited in the cycle itself.
• The profile has been modified with a program other than the profile editor.
• Machine parameter DIAMPROG of the axes of the profile is not properly set.
SOLUTION Enter the cycle screen an edit each profile of the pocket to find the arc that is
programmed wrong. Once the arc and the wrong profile have been found, go to the
editor and modify the arc.
1885 'Pocket with islands: Wrong pocket geometry'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE Some of the profiles making up the pocket has some path programming error
(rounding, chamfer, etc.).
SOLUTION Enter the cycle screen an edit each profile of the pocket to find the error. Once found
the error and which profile it's in, go to the editor and modify it.
1886 'Pocket with islands: Wrong roughing tool's penetration angle'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The value of the penetration angle (Ae) of the tool programmed in the roughing
operation is smaller than or equal to 0º or greater than 90º.
SOLUTION Program a value greater than 0º and smaller than or equal to 90º.
1887 'Pocket with islands: Wrong penetration angle of the semi-finishing tool'
DETECTION Execution of a 3D pocket cycle with islands.
CAUSE The value of the penetration angle (Ae) of the tool programmed in the semi-finishing
operation is smaller than or equal to 0º or greater than 90º.
SOLUTION Program a value greater than 0º and smaller than or equal to 90º.
To Next Page
Loading...
