CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 26 of 128
Errors 1000-1999
1181 '#LINK: An axis active in G201 cannot be defined as slave'
DETECTION During execution.
CAUSE An attempt has been made to define as slave of a coupling an axis that is in additive
manual mode with function G201.
SOLUTION If the coupling is desired, the additive manual mode of the axis may be canceled with
function G202.
1182 '#LINK: too many couplings programmed'
DETECTION During execution.
CAUSE The number of coupling to be activated with the #LINK instruction exceeds the
maximum allowed.
SOLUTION The maximum number of couplings that can be activated with the #LINK instruction
is limited depending on the number of axes of the system (without counting spindles).
The limit is the number of axes - 3.
1183 'The #LINK instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE Only the block number of a label may be programmed in the same block as a "#"
instruction.
SOLUTION Check the program.
1184 '#LINK: The master and slave axes are the same'
DETECTION During execution.
CAUSE An attempt has been made to activate a coupling with the same axis as master and
slave.
SOLUTION The master and slave axes must be different.
1185 '#LINK: An axis cannot be a slave of several masters'
DETECTION During execution.
CAUSE An attempt has been made to define an axis as slave of different masters.
SOLUTION A slave axis has only one master axis.
1186 ''#LINK: A master axis cannot be a slave in another coupling and vice versa'
DETECTION During execution.
CAUSE An attempt has been made to define an axis as master in a coupling and as slave
in another.
SOLUTION The axis cannot be master and slave at the same time.
1187 '#AXIS: repeated axis name'
DETECTION During execution.
CAUSE The same axis has been programmed more than once in the instruction.
SOLUTION Check the program.
1188 '"["not expected'
DETECTION During execution.
CAUSE Syntax error in the instruction.
SOLUTION Check the syntax of the instruction in the programming manual.
1189 '#MPG: too many parameters'
DETECTION During execution.
CAUSE The instruction has been programmed with more parameters than allowed.
SOLUTION The #MPG instruction admits a maximum of three parameters. Each one of them
represents the distance moved per handwheel pulse in each position of the switch.
1190 '#MPG: Negative or zero handwheel resolutions are not allowed'
DETECTION During execution.
CAUSE A negative or zero value has been programmed for handwheel resolution.
SOLUTION The movement distance per handwheel pulse must be positive and other than zero.
To Next Page
Loading...
