Fagor CNC8 070 - Duplicate M in the Table; Restart the CNC to Assume the New Value; Wrong Axis Name or Undefined Axis Name; Wrong Machine Parameter Value

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 2 of 128
Errors 0000-0999
0040 'M before-before or Before-After with subroutine does not admit movements in
the block'
DETECTION Machine parameter validation.
CAUSE An M function with associated subroutine cannot be Before-Before or Before-After.
The subroutine associated with an M function is always executed at the end of the
block, after the rest of the block.
• Before-Before means that the M is executed before the rest of the block and the
synchronization with the PLC is also done before the block.
• Before-After means that the M is executed before the rest of the block and the
synchronization with the PLC is done after the block.
SOLUTION Either define the M without subroutine or define the M as After-After.
0041 'Duplicate M in the table'
DETECTION Machine parameter validation.
CAUSE There is an M repeated in the M table.
SOLUTION Delete the repeated M from the table.
0042 'Wrong machine parameter value'
DETECTION Machine parameter validation.
CAUSE Machine parameter out of range.
SOLUTION Set the machine parameter to a value between the maximum and minimum values
shown at the warning.
0043 'Restart the CNC to assume the new value'
DETECTION Machine parameter validation.
CAUSE A machine parameter has been modified that requires restarting the CNC in order
to assume the new value.
SOLUTION Restart the CNC.
0044 'Wrong axis name or undefined axis name'
DETECTION Machine parameter validation.
CAUSE The wrong name has been assigned to a machine parameter that represents the
name of an axis.
SOLUTION Assign a correct name to the parameter. The first character is mandatory A, B, C, X,
Y, Z, U, V or W and the second one optional, a number from 1 to 9.
0045 'Wrong spindle name'
DETECTION Machine parameter validation.
CAUSE The wrong name has been assigned to a machine parameter that represents the
name of a spindle.
SOLUTION Assign a correct name to the parameter. The first character S is mandatory and the
second one optional, a number from 1 to 9.
0046 'Nonexistent axis'
DETECTION Machine parameter validation.
CAUSE A machine parameter that represents the name of an axis has been assigned a name
that does not exist in parameter AXISNAME.
SOLUTION Assign a correct name to the parameter. A name that appears in AXISNAME.
0047 'A main axis cannot be defined as slave'
DETECTION Machine parameter validation.
CAUSE In a Gantry pair, an axis has been set as slave that is the master of another pair.
SOLUTION Do not set it as slave.
0048 'An axis cannot be a slave of several masters'
DETECTION Machine parameter validation.
CAUSE In a Gantry pair, an axis has been set as slave that is already a slave in another pair.
SOLUTION Do not set it as slave again.