Fagor CNC8 070 - 6031 Incompatible Software Version at Compci;Remote Nodes; 6030 Position Increment Limit Exceeded at the CAN Counter Node; 6029 Position Increment Limit Exceeded at the CNC

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 103 of 128
Errors 6000-6999
6029 'Position increment limit exceeded at the CNC'
CAUSE Excessive position increment of an analog axis. Hardware failure at the counter node,
Accesses to the COMPCI (connections), etc.
SOLUTION Contact our technical service department.
6030 'Position increment limit exceeded at the CAN counter node'
CAUSE Excessive position increment of an analog axis. Hardware failure of the counter node.
SOLUTION Contact our technical service department.
6031 'Incompatible software version at COMPCI/Remote nodes'
DETECTION During startup.
CAUSE Incompatible software version at CNC and COMPCI or remote modules.
SOLUTION Update the software of the COMPCI and remote modules. (itfcboot.exe).