Fagor CNC8 070 - 1149: The Programmed G36;G37;G38;G39 Cannot be Executed; 1147: The Path after a G38 Must be Linear; 1146: The Path before a G37 Must be Linear; 1142: The #TIME Instruction Must be Programmed Alone in the Block

CNC8070
R
EF
. 0402
OF 128
E
RROR SOLUTIONS
Page 22 of 128
Errors 1000-1999
1141 'The $CONTINUE instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE Control instructions must be programmed alone in the block.
SOLUTION Check the program.
1142 'The #TIME instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The dwell must be programmed in the same block as the #TIME instruction.
SOLUTION Check the program.
1146 'The path before a G37 must be linear'
DETECTION During execution.
CAUSE The motion block before the tangential entry is not linear.
SOLUTION Check the program.
1147 'The path after a G38 must be linear'
DETECTION During execution.
CAUSE The motion block after the tangential exit is not linear.
SOLUTION Check the program.
1149 'The programmed G36/G37/G38/G39 cannot be executed'
DETECTION During execution.
CAUSE The desired joining path between the first and the last block cannot be carried out
with the programmed radius.
SOLUTION Check the value programmed for the radius of the joining path. Check that the joint
is actually possible between the first and the last block.
1150 'Functions G36/G37/G38/G39 must be followed by a motion block'
DETECTION During execution.
CAUSE The second motion block for the joining path is missing.
SOLUTION Do not program any block between the G function that defines the joining path and
the second motion block.
1151 'Functions G8/G36/G37/G38/G39 must be preceded by a motion block'
DETECTION During execution.
CAUSE The first motion block for the joining path is missing.
SOLUTION Do not program any block between the G function that defines the joining path and
the first motion block.
1152 'Too many nested subroutines'
DETECTION During execution.
CAUSE The maximum level of nesting allowed by the CNC has been exceeded.
A subroutine may be called from a main program (or a subroutine), another subroutine
from this subroutine and so forth. The CNC limits this calls to a maximum of 20 nesting
levels.
SOLUTION Redesign the program decreasing the nesting level on calls to subroutines (local and
global).
1153 'Too many local subroutines defined in the program'
DETECTION During execution.
CAUSE The maximum number of local subroutines allowed by the CNC has been exceeded.
This maximum is 100.
SOLUTION Redesign the program decreasing the number of local subroutines defined.