CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 82 of 128
Errors 2000-2999
2116 'Error when activating the spline'
DETECTION During execution.
CAUSE An attempt has been made to activate a spline mode without canceling the previous
one.
SOLUTION Before activating it, cancel the previous one.
2118 'SPLINE: wrong type of spline'
DETECTION During execution.
CAUSE The type of spline programmed is not allowed.
SOLUTION Program the type of spline as indicated in the manual.
2119 'SPLINE: The type cannot be changed while splines are active'
DETECTION During execution.
CAUSE An attempt has been made to change the type of spline while another one was active.
SOLUTION Cancel the spline before programming another one of another type.
2121 'Circular paths (arcs) are not allowed while splines are active'
DETECTION During execution.
CAUSE An arc has been programmed while splines were active.
SOLUTION Cancel the spline mode before programming the arc.
2122 'Polynomial blocks are not allowed while splines are active'
DETECTION During execution.
CAUSE A polynomial movement has been programmed while splines were active.
SOLUTION Cancel the spline mode before programming the polynomial.
2123 'Programming not allowed while splines are active'
DETECTION During execution.
CAUSE A change of the coordinate system has been programmed while splines were active.
SOLUTION Cancel the spline mode before programming the change of coordinate system.
2124 'SPLINE: It requires at least two main axes'
DETECTION During execution.
CAUSE The command spline has been programmed while having only one axis in the
channel.
SOLUTION Program the movements without spline mode.
2125 'SPLINE: error when calculating the tangent'
DETECTION During execution.
CAUSE A point has been programmed more than once.
SOLUTION Program different points.
2126 'Positive software limit overrun in the spline'
DETECTION During execution.
CAUSE The path generated by the CNC to work in SPLINE mode is out of the active travel
limits.
SOLUTION Cancel the SPLINE mode in the block or blocks that cause the error.
2127 'Negative software limit overrun in the spline'
DETECTION During execution.
CAUSE The path generated by the CNC to work in SPLINE mode is out of the active travel
limits.
SOLUTION Cancel the SPLINE mode in the block or blocks that cause the error.
2128 'Helical path programmed wrong'
DETECTION During execution.
CAUSE One of the parameters of the helical path is missing or is wrong. The pitch has been
programmed, but not the depth, or both the pitch and then end point are missing or
the depth, the pitch and the end point are not compatible with each other.
SOLUTION Program the end point compatible with the pitch and the depth. If they are full turns,
program the pitch and the depth.
To Next Page
Loading...
