Fagor CNC8 070 - 1744 Pre-Emptied Pocket: T = 0; 1745 Pre-Emptied Pocket: P = 0; 1746 PRE-EMPTIED POCKET: Tool Diameter Smaller than DELTA; 1747 PRE-EMPTIED POCKET: Tool Diameter Greater than the Pocket

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 65 of 128
Errors 1000-1999
1744 'PRE-EMPTIED POCKET: T = 0'
DETECTION Executing pre-emptied pocket cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1745 'PRE-EMPTIED POCKET: P = 0'
DETECTION Executing pre-emptied pocket cycle.
CAUSE P (pocket depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1746 'PRE-EMPTIED POCKET: tool diameter smaller than DELTA'
DETECTION Executing pre-emptied pocket cycle.
CAUSE The diameter of the roughing or finishing tool is smaller than the roughing or finishing
pass in the main plane.
SOLUTION Decrease the size of the milling pass in XY (DELTA) or machine with a tool that has
a larger diameter.
1747 'PRE-EMPTIED POCKET: tool diameter greater than the pocket'
DETECTION Executing pre-emptied pocket cycle.
CAUSE The diameter of the roughing or finishing tool is greater than the pocket dimensions
L or H.
SOLUTION Choose a tool of a smaller diameter to make the pocket.
1748 'PRE-EMPTIED POCKET: Finishing tool diameter smaller than delta'
DETECTION Executing pre-emptied pocket cycle.
CAUSE The diameter of the finishing tool is smaller than the finishing stock in the main plane
(delta).
SOLUTION Choose a tool of a larger diameter to make the pocket.
1749 'PRE-EMPTIED POCKET: R <r'
DETECTION Executing pre-emptied pocket cycle.
CAUSE The outside diameter of the pocket (R) is smaller than the inside radius (r).
SOLUTION Set parameters R and r with values so R >r
1750 'RECTANGULAR BOSS :F = 0'
DETECTION Executing rectangular boss cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1751 'RECTANGULAR BOSS:S = 0'
DETECTION Executing rectangular boss cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1752 'RECTANGULAR BOSS :T = 0'
DETECTION Executing rectangular boss cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1753 'RECTANGULAR BOSS:P = 0'
DETECTION Executing rectangular boss cycle.
CAUSE P (boss depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1754 'RECTANGULAR BOSS :tool diameter smaller than DELTA'
DETECTION Executing rectangular boss cycle.
CAUSE The diameter of the roughing or finishing tool is smaller than the roughing or finishing
pass in the main plane.
SOLUTION Decrease the size of the milling pass in XY (DELTA) or machine with a tool that has
a larger diameter.