Fagor CNC8 070 - 1364 Too Many Array Variable Indexes; 1365 Negative Spindle Speed Not Allowed; 1363 Wrong Declaration of Array Variables; 1360 G33;G63;G95;G96;G97 Not Allowed While the C Axis Is Active

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 41 of 128
Errors 1000-1999
1360 'G33/G63/G95/G96/G97 not allowed while the C axis is active'
DETECTION During execution.
CAUSE A G33/G63/G95/G96/G97 function has been programmed while the C axis was
active.
SOLUTION The C axis may be deactivated with the #CAX OFF instruction.
1363 'Wrong declaration of array variables'
DETECTION During execution.
CAUSE User variables (V.P, V.S) must be declared between #VAR/#ENDVAR instructions.
SOLUTION Check the program.
1364 'Too many array variable indexes'
DETECTION During execution.
CAUSE A multi-dimensional array user variable has been defined with more than 4
dimensions.
SOLUTION Check the program.
1365 'Negative spindle speed not allowed'
DETECTION During execution.
CAUSE A negative spindle speed has been programmed in the block.
SOLUTION The programmed spindle speed must always be positive, except with function G63.
1367 'A gear change and a spindle movements cannot be simultaneous'
DETECTION During execution.
CAUSE An M function for spindle movement and function G112 (parameter set change) have
been programmed in the same block.
SOLUTION Program them in different blocks.
1368 'The circle's center and radius cannot be programmed at the same time'
DETECTION During execution.
CAUSE The center and the radius of a circular interpolation has been programmed.
SOLUTION In a circular interpolation, one must program the coordinate of the last point and the
radius or the center of the circle.
1369 '#HSC: programming not allowed'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
1370 '#HSC: double programming'
DETECTION During execution.
CAUSE The activation or deactivation of HSC has been programmed twice in the block.
SOLUTION Program only #HSC ON or #HSC OFF in the block.
1374 'M02/M30 expected'
DETECTION During execution.
CAUSE M02 or M30 has not been programmed at the end of the main program.
SOLUTION Check the program.
1375 'M17/M29/#RET expected'
DETECTION During execution.
CAUSE M17, M29 or #RET has not been programmed at the end of the subroutine.
SOLUTION Check the program.