CNC8070
R
EF
. 0402
OF 128
E
RROR
SOLUTIONS
Page 44 of 128
Errors 1000-1999
1394 'The subroutine associated with the G function does not exist'
DETECTION During execution.
CAUSE The possible causes are:
• Function G74 has been programmed alone in the block, but it has no subroutine
associated with machine parameter REFPSUB.
• A function G180-G189 has been programmed alone in the block, but it has no
subroutine associated with machine parameter OEMSUB.
SOLUTION Define in the corresponding parameter the name of the subroutine to be executed
and validated.
1395 'Function G74 with associated subroutine must be programmed alone in the
block'
DETECTION During execution.
CAUSE Only the block number or a label may be programmed in the same block as function
G74 in order to execute the associated subroutine.
SOLUTION Program them in different blocks.
1396 'Programming not allowed in MDI'
DETECTION During execution.
CAUSE That command cannot be executed in MDI.
SOLUTION Execute that command within the program.
1397 'The position programmed for the Hirth axis is wrong'
DETECTION During execution.
CAUSE The coordinate programmed for the Hirth axis does not correspond to a whole step.
SOLUTION It is only possible to program coordinates from REFVALUE plus "n" times HPITCH.
1398 'An axis with parameter HIRTH = NO cannot be activated as Hirth axis'
DETECTION During execution.
CAUSE An attempt has been made to activate or deactivate (G171 and G170) a Hirth axis
while its machine parameter HIRTH = NO.
SOLUTION Set machine parameter of the axis: HIRTH = Yes.
1399 'The axis cannot be activated as Hirth'
DETECTION During execution.
CAUSE An attempt has been made to activate a Hirth axis when:
• It is the first or second axis of the plane and tool radius compensation is active.
• It is the first or second axis of the plane and collision detection is active.
• It is one of the first three axes and #CS or #ACS transformations are active.
• It is one of the first five axes and 5-axis transformations like #RTCP, #TLC or
#TOOL ORI are active.
SOLUTION Check the program.
1400 'Tool length change is not possible while RTCP is active'
DETECTION During execution. This error would come up in the first unofficial versions.
CAUSE When trying to make a tool change while RTCP was active.
SOLUTION Cancel the RTCP, make the tool change and activate the RTCP function again.
1401 '#TLC ON not allowed without prior deselection'
DETECTION During execution.
CAUSE An attempt has been made to activate #TLC ON when it was already active.
SOLUTION Check the program.
1402 '#LINK: The master and slave axes must have the same parameters HIRTH and
HPITCH'
DETECTION During execution.
CAUSE An attempt has been made to activate a coupling where:
• The master is a Hirth axis but not the slave or viceversa.
• Both are Hirth axes, but the HPITCH is different.
SOLUTION Coupling (slaving) is only possible if both or none of the axes is a Hirth axis The Hirth
pitch of the axes may be modified in the machine parameter table, HPITCH.
To Next Page
Loading...
